For this project, we learned a few different tolerance fit types so we could 3D print a object/toy that used at least 1 kind of fit. I chose to make a "Sword in the Stone" toy that had a lock, two base parts that fit together, and a sword that could be inserted and taken if the lock piece is not inside of the base.
Step 4. The two base pieces are pushed together, then the sword is placed in the rectangular hole that is crated by the two base pieces fitting together and finally you push the cylindrical lock piece through the whole in the bottom of both base pieces and the lock piece, making it that you cannot pull the sword.
I do not have the physical prototype of the model due to the fact that I lost both base pieces so refer to the slideshow for dimensions.
I do not have the physical prototype of the model due to the fact that I lost both base pieces so refer to the slideshow for dimensions.
Overall, this whole project was a mess for me, the printer at first failed to print the sword and lock piece causing me to barely finish this project. I learned to use fits and learned tolerances I personally found it difficult to figure out how to piece this together and how to get the lock to fit.